Delphi Suspension Stabilizer Bar Bushing Kit TD987W
Delphi Suspension Stabilizer Bar Bushing Kit TD987W

Rear Sway Bar Bushing Kit for 2003-2011 Saab 9-3 - Delphi TD987W

Be the first to review this product
$12.99
MPN: TD987W
UPC: 689604264096
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Ask an Expert
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD987W
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD987W
$12.99

Help quiet suspension rattle and keep your rear stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD987W. This rear sway bar bushing kit installs as a direct-fit replacement for the 2003-2011 SAAB 9-3. The bushings cushion the stabilizer bar where it mounts to the chassis, letting the bar twist during body roll while damping the noise and movement that worn, cracked originals allow.

  • Designed to OE standards: Delphi applies its OE expertise to its aftermarket steering portfolio, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
  • Built for consistent life: manufactured for consistent service life.
  • Quieter operation: manufactured to reduce noise.
  • Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt spray.

If worn stabilizer bar bushings are the cause of a clunk or rattle over bumps, this kit replaces them and helps restore the vehicle's smooth ride. Order the correct quantity for your application.

Interchange: 24 45 7843
24457843 · 444162 · V400583

This part cross-references / interchanges with the following part numbers:

24 45 7843, 444162, V400583

Frequently Asked Questions

What does the Delphi TD987W bushing kit do?

It replaces the bushings that cushion the rear stabilizer bar at its chassis mounts, letting the bar twist during body roll while damping noise and movement.

What vehicle does this kit fit?

It is a direct-fit replacement for the 2003-2011 SAAB 9-3. See the Buyer's Guide tab to confirm the exact engine and trim for your vehicle.

Is this a front or rear sway bar bushing kit?

It is cataloged for the rear position on the 2003-2011 SAAB 9-3.

What are signs the stabilizer bar bushings may need replacing?

Clunking, knocking, or rattling over bumps, increased body roll, and cracked or deteriorated bushings are common signs. Diagnose the cause before replacing.

What part numbers does this kit interchange with?

It cross-references 24 45 7843 (24457843), 444162, and V400583.

Related Products

!