Delphi Suspension Stabilizer Bar Link P/N:TC8056
Tie the rear stabilizer bar back into the suspension and quiet the clunks with the Delphi Suspension Stabilizer Bar Link TC1472, a rear sway bar link built on Delphi's OE safety technology. It installs as a direct-fit replacement for a wide range of BMW models, including the 2001-2007 525I, 1997-2003 540I, 2006-2010 550I, 2002-2005 745I and 2000-2006 X5 — see the Buyer's Guide tab for the full list of 22 applications and engine details.
Delphi applies its OE expertise to the aftermarket steering and suspension portfolio, testing to the extreme: parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, while extensive dimensional and material analysis targets close OE-to-aftermarket compatibility.
A stabilizer bar link connects the rear sway bar to the suspension; worn links commonly show up as clunking or rattling over bumps and reduced body control in turns. Sold individually; links wear as a pair, so replacing both sides together is good practice.
Interchange: 3332 1090 030 · 3332 1091 620 · 3332 6770 749 · 101-5811
33321090030 · 33321091620 · 33326770749 · 1015811 · CA145825PR · CA14595 · CA14825 · CK642132 · K642132 · RK642132 · CMS101426 · JTS512
This part cross-references / interchanges with the following part numbers:
What is a stabilizer bar link and what does this part do?
It connects the rear stabilizer (sway) bar to the suspension, helping control body roll. This Delphi TC1472 replaces a worn or damaged rear link.
Is this a front or rear sway bar link?
This is a rear stabilizer bar link. Confirm your vehicle in the Buyer's Guide tab before ordering.
Which vehicles does the TC1472 fit?
It fits many BMW models such as the 525I, 528I, 530I, 535I, 540I, 545I, 550I, 645CI, 650I, 740I, 745I, 760LI and X5. See the Buyer's Guide tab for years and the full list.
How is this Delphi link tested for durability?
Delphi tests to the extreme: parts withstand below -40°C and over 120°C, endure 720 hours of salt spray, are fatigue tested, and are machined to micron tolerances for smooth joint operation.
Do I need to replace both sides?
The link is sold individually. Because both sides wear at a similar rate, replacing them together is good practice for balanced handling.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.