Delphi Suspension Stabilizer Bar Link P/N:TC5410
Help keep body roll in check up front with the Delphi Suspension Stabilizer Bar Link (P/N: TC2132). This front sway bar link ties the front stabilizer bar to the suspension so the bar can do its job of resisting lean through corners, and it drops in as a direct-fit replacement for a range of Mercedes-Benz cars, among them the 2007-2009 Mercedes-Benz CLK550, 2002-2007 Mercedes-Benz C230 and 2001-2005 Mercedes-Benz C240; see the "Vehicles it fits" section for the full list and engine details.
Delphi applies its OE engineering to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part. Delphi tests to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray.
If a worn sway bar link is the source of front-end rattle or clunking over bumps and sloppy body roll, this is the replacement.
Interchange: 101-6767 · MB-L617 · 203 320 21 89 · 203 320 26 89 · 203 320 29 89 · A203 320 2189 · A203 320 2689 · A203 320 2989 · 545-1564
1016767 · MBL617 · 2033202189 · 2033202689 · 2033202989 · A2033202189 · A2033202689 · A2033202989 · 5451564 · KSLF4070 · SL28185 · K80491 · SL658 · MK80491 · JTS424
This part cross-references / interchanges with the following part numbers:
What does a stabilizer bar link do?
It connects the front stabilizer (sway) bar to the suspension so the bar can resist body lean during cornering, helping control roll and keep the front end tight.
Does the Delphi TC2132 fit my vehicle?
It's a direct-fit front link for various Mercedes-Benz models, including the 2007-2009 Mercedes-Benz CLK550, 2002-2007 Mercedes-Benz C230 and 2001-2005 Mercedes-Benz C240. Check the "Vehicles it fits" section for the full list.
What are signs this sway bar link may need replacing?
A worn link often produces rattling or clunking from the front over bumps and looser, rolling handling through turns. Diagnose the cause before replacing.
Should I replace both sides at once?
Front links wear at a similar rate, so replacing the link on both sides together is good practice for balanced, predictable handling.
How is this Delphi link built for durability?
It uses ultrasonic molding to help prevent weld breakage, is fatigue tested, is machined to micron tolerances for smooth joint operation, and has anti-corrosion protection applied.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.