Delphi Suspension Stabilizer Bar Link Kit P/N:TC2051
$18.99
(You save)
Keep your front stabilizer bar firmly tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2051. This front sway bar link connects the stabilizer bar to the control arm or strut, transferring load side-to-side to limit body roll and help keep handling flat through turns. It's a direct-fit replacement for the 2000-2001 Volkswagen Beetle, 1999-2002 Volkswagen Golf, and 2000-2001 Volkswagen Jetta — see the Buyer's Guide tab for engine-level details.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close compatibility to the original part.
Tested for durability: fatigue tested to resist failure, and validated below -40°C, above 120°C, and through 720 hours of salt spray.
Ultrasonic molding: built with ultrasonic molding to help prevent future weld breakage.
Precision joints: machined to micron tolerances for durable, smooth joint operation, with anti-corrosion protection applied to each part.
Worn stabilizer bar links often show up as clunking or rattling over bumps and looser, softer cornering — signs this stabilizer bar link kit may need replacing. Replacing links on both sides together helps keep front handling balanced.
What does the Delphi TC2051 stabilizer bar link kit do?
It connects the front stabilizer (sway) bar to the suspension, transferring load side-to-side to limit body roll and help keep handling flat through turns.
Which vehicles does the TC2051 fit?
It's a direct-fit replacement for the 2000-2001 VW Beetle, 1999-2002 VW Golf, and 2000-2001 VW Jetta. Check the Buyer's Guide tab for engine-level details.
What are signs my sway bar link may need replacing?
Common signs include clunking or rattling over bumps and looser, softer cornering. Have the suspension inspected to confirm the link is the cause before replacing.
How was this Delphi link tested?
Delphi fatigue tests its sway bar links to resist failure and validates them below -40°C, above 120°C, and through 720 hours of salt spray exposure.
Should I replace both front sway bar links at once?
Replacing the links on both sides together helps keep front handling balanced and predictable, though your service procedure governs the final job.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC2051
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
Keep body roll in check and quiet the rattles with the Delphi Front Suspension Stabilizer Bar Link Kit TC6540. This front sway bar link connects the stabilizer bar to the suspension so the bar can...
Keep body roll in check and restore a tight, controlled feel over uneven pavement with the Delphi Suspension Stabilizer Bar Link Kit TC2409. This kit connects the rear stabilizer bar to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
