Take the guesswork out of front strut service with the Monroe Quick-Strut Suspension Strut and Coil Spring Assembly 272322, a fully assembled front unit that drops in as a direct-fit replacement for the 2004-2008 Acura TL. This all-in-one design bundles the strut, application-specific coil spring, and preassembled upper mount into a single unit, so replacement can be quicker, safer, and easier with no need for a spring compressor.
A protective coating resists rust and corrosion, and salt spray testing confirms it's ready for the elements. Backed by Monroe's Limited Lifetime Warranty and Feel the Difference Guarantee.
Interchange: LS3380321B · 32AC1100
This part cross-references / interchanges with the following part numbers:
What vehicles does the Monroe 272322 fit?
It is a front strut and coil spring assembly for the 2004-2008 Acura TL. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this a front or rear assembly?
It is a front Quick-Strut suspension strut and coil spring assembly.
Do I need a spring compressor to install it?
No. It ships as a single, fully assembled unit that includes the components needed for strut replacement, so a spring compressor is not required.
Should I replace both front struts at the same time?
Replacing struts in pairs is recommended for balanced ride and handling. This listing is for one assembly, so order two to do both sides.
What does the coil spring do on this assembly?
The application-specific coil spring is calibrated to the OE design to help restore ride height and support the vehicle's weight.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
