Smooth out a worn front corner and bring back factory ride height with the Monroe Quick-Strut Suspension Strut and Coil Spring Assembly 182977, a fully preassembled front-left unit for the 2014-2019 Chevrolet Impala. It arrives as a complete, ready-to-bolt-in module — strut, application-specific coil spring, and upper strut mount in one — so no spring compressor is needed during installation.
Backed by Monroe's Limited Lifetime Warranty and Feel the Difference Guarantee.
Interchange: LS3486811L · 33GM1213
This part cross-references / interchanges with the following part numbers:
What vehicle does this Quick-Strut fit?
It is a direct-fit front-left assembly for the 2014-2019 Chevrolet Impala. See the Buyer's Guide tab to confirm the exact application for your vehicle.
What position is this assembly for?
This is the front-left (driver-side) Suspension Strut and Coil Spring Assembly, MPN 182977.
Do I need a spring compressor to install it?
No. It ships as a fully assembled, single unit with the strut, coil spring, and upper mount preassembled, so no spring compressor is required.
What comes in this unit?
It includes the strut, an application-specific coil spring, and a preassembled upper strut mount together in one bolt-in assembly.
Should I replace both sides at once?
This listing is for one front-left assembly. Replacing struts as a pair on the same axle is recommended for balanced, even ride and handling.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
