KYB Suspension Strut and Coil Spring Assembly P/N:SR4318
$239.99
(You save)
Restore factory ride height and control at the front-left corner with the KYB Strut Plus SR4318, a corner unit that drops in as a direct-fit replacement for the 2011-2015 Chevrolet Cruze and 2016 Chevrolet Cruze Limited. As an original-equipment supplier, KYB pre-assembles the strut, mount and spring into one unit for professional results — a favorite among shoppers searching for KYB complete struts.
OE-Restoring KYB Excel-G strut: built with a stronger steel outer shell and application-specific, precision-designed damping valves.
High-carbon steel coil spring: application-engineered to match the strut and help restore ride height within OE specifications while controlling weight without sacrificing ride quality.
Side-specific design: left and right part numbers with side-specific components, as the vehicle manufacturer intended.
Engineered for electronic safety systems: designed to help vehicles equipped with ESC, ABS and similar systems perform as intended.
A strut assembly supports vehicle weight, sets ride height, acts as the steering pivot and helps control vehicle stability. Assembled in the USA and shipped pre-assembled, this KYB front strut assembly installs without compressing a spring at the bench.
Interchange: 272627 · 282627 · 372664 · 382664
This part cross-references / interchanges with the following part numbers:
272627, 282627, 372664, 382664
Frequently Asked Questions
Does this KYB Strut Plus fit my Chevy Cruze?
Yes. SR4318 is a direct-fit front-left assembly for the 2011-2015 Chevrolet Cruze and 2016 Chevrolet Cruze Limited. Check the Buyer's Guide tab to confirm your specific vehicle.
What is included in this complete strut and coil spring assembly?
It combines a KYB Excel-G strut, a high-carbon steel coil spring and the mount, pre-assembled into a single front-left corner unit.
Is this a left or right side unit?
This is the front-left unit. KYB uses separate left and right part numbers with side-specific design and components, as the vehicle manufacturer intended.
Do I need a spring compressor to install this KYB quick strut assembly?
No. It ships pre-assembled as a complete corner unit, so you avoid handling a compressed coil spring during installation.
Should I replace both front struts at the same time?
Replacing struts in axle pairs is recommended for balanced handling and ride height. This listing is one front-left assembly; order the matching opposite-side part separately.
Write a Review
KYB
KYB Suspension Strut and Coil Spring Assembly P/N:SR4318
Bring back factory ride height and steady control with the KYB Strut-Plus (P/N SR4033), a pre-assembled front complete strut and coil spring assembly that drops in as a direct-fit replacement for the...
Bring back factory ride height and controlled handling with the KYB strut plus assembly, P/N SR4067 — a complete strut and coil spring assembly that installs in the rear left corner of the 1993-2002...
Bring back factory ride height and steering control with the KYB strut plus — the KYB Strut-Plus complete strut and coil spring assembly (SR4082), a direct-fit front replacement for the 2004-2005...
Restore your Camry's front-right ride height and handling with the KYB strut plus SR4108, a complete strut and coil spring assembly that drops in as a direct-fit replacement for the 2007-2009 Toyota...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
