Keep your manual transmission turning quietly with the Timken Manual Trans Input Shaft Bearing 1207SL, a maximum-capacity single-row radial ball bearing with a shield opposite the snap ring. It supports the input shaft at the front of the gearbox and installs as a direct-fit replacement on the listed classic Dodge trucks and vans — covering the 1957-1959 Dodge D100 Pickup, the 1957-1959 and 1968 Dodge W100 Pickup, the 1960-1967 Dodge D100 and W100 Series, and the 1967-1968 Dodge A108 Van. Each listed application uses two of these bearings.
If a worn or noisy input shaft bearing is the cause of your gear whine, this replaces it.
Interchange: 207AZNR · 207ZNR · 207ZNRJ
This part cross-references / interchanges with the following part numbers:
What is this part?
It's the Timken 1207SL, a maximum-capacity single-row radial deep groove ball bearing with a shield opposite the snap ring, used as a manual transmission input shaft bearing at the front of the gearbox.
Which vehicles does it fit?
It fits the 1957-1959 Dodge D100 Pickup, the 1957-1959 and 1968 Dodge W100 Pickup, the 1960-1967 Dodge D100 and W100 Series, and the 1967-1968 Dodge A108 Van. See the Buyer's Guide tab for full details.
How many do I need?
Each listed application uses two bearings, so order two for a complete replacement. The listing is for a single bearing.
What numbers does it interchange with?
It cross-references 207AZNR, 207ZNR, and 207ZNRJ.
What are signs this bearing may need replacing?
Gear whine, growling, or noise from the front of the transmission can be signs a worn input shaft bearing may need replacing. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
