Rear Wheel Bearing and Hub Assembly for 2005-2018 Volkswagen Jetta & More - Timken 512319

$234.99

Vehicles this part fits

    Part number: 512319
    UPC: 085706019570
    Condition: New
    Weight: 5.00 LBS
    Item Package Quantity: 1
    $234.99
    Adding to cart… The item has been added

    Have questions?

    Timken Wheel Bearing and Hub Assembly P/N:512319
    Timken Wheel Bearing and Hub Assembly P/N:512319
    $234.99
    $234.99

    Timken 512319 rear wheel bearing and hub assembly for the 2005-2018 Volkswagen Jetta and other vehicles carries the rear wheel and lets it turn freely. This Timken wheel bearing comes preset, pre-greased and pre-sealed as one hub unit.

    • Low runout to reduce noise and vibration
    • Seals with a reinforced outer case, ribbed rubber inner diameter, contamination exclusion system and vent holes to prevent installation damage
    • Bearings with precision profiles, uniform internal geometry and enhanced surface finishes to increase load carrying capacity and extend bearing life
    • ABS sensors are 100% tested to monitor wheel speed for the anti-lock braking system

    Quick facts

    • Part: Timken 512319 wheel bearing and hub assembly
    • Fits: 2005-2018 Volkswagen Jetta and other vehicles
    • Position: Rear
    • Condition: New

    A humming or growling noise that rises with speed, or vibration from the rear, can mean a worn wheel bearing. A worn tire, a warped rotor or a worn suspension bushing can be behind these signs too, so find the cause before buying.

    Fits

    This wheel bearing and hub assembly fits the 2005-2018 Volkswagen Jetta, the 2012-2022 Volkswagen Passat and the 2009-2017 Volkswagen Tiguan, along with other Volkswagen and Audi models. Open the "Vehicles it fits" section to check your exact model and engine. The 2005-2018 Volkswagen Jetta takes two. This listing is one assembly; the other side of that axle is normally done at the same time.

    Specifications

    Fit and size

    • Position: Rear
    • Quantity per vehicle: 2
    • Wheel studs: 5
    • Bolt circle diameter: 112.29 mm (4.42 in)
    • Flange diameter: 136.53 mm (5.375 in)
    • Hub pilot diameter: 79 mm (3.11 in)
    • Brake pilot diameter: 65 mm (2.56 in)
    • Wheel pilot diameter: 57.15 mm (2.25 in)

    Build and materials

    • Drive type: Non-driven
    • Construction: Hub unit assembly, preset, pre-greased and pre-sealed
    • ABS sensor: 100% tested to monitor wheel speed
    • Condition: New

    Interchange: 051-6239 · 405.33003E
    WE60687 · BR930622

    This part cross-references / interchanges with the following part numbers:

    WE60687, 051-6239, 405.33003E, 512319, BR930622

    Frequently Asked Questions

    Are these 2005-2018 VW Jetta wheel bearings for the rear axle?

    Yes. Timken 512319 fits the 2005-2018 Volkswagen Jetta at the rear. For another car, check your exact model in the "Vehicles it fits" section.

    What bolt circle do these Timken wheel hubs have?

    Timken 512319 has a 112.29 mm (4.42 in) bolt circle with 5 wheel studs. The wheel pilot diameter is 57.15 mm (2.25 in).

    How do I know if Timken hub bearings are going bad?

    A hum or growl that rises with speed, or vibration from a rear corner, can mean a worn bearing. Have it checked promptly rather than driving on a bearing you suspect is failing.

    Is the Timken wheel bearing and hub assembly a driven or non-driven hub?

    Non-driven. Timken 512319 is a non-driven hub unit with a 136.53 mm (5.375 in) flange diameter and a 79 mm (3.11 in) hub pilot.

    Does Timken 512319 replace WE60687?

    Yes. WE60687 is listed as an interchange number for Timken 512319, a rear wheel bearing and hub assembly.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review