Timken HA590253 wheel bearing and hub assembly for the 2007-2018 Nissan Altima and other vehicles mounts the wheel and lets it turn smoothly. This Timken wheel bearing is non-driven, so it carries the wheel without transmitting engine torque.
- Low runout to reduce noise and vibration
- Seals with a reinforced outer case, ribbed rubber inner diameter and contamination exclusion system to promote positive sealing
- Vent holes in the seal to prevent installation damage
- Bearings with precision profiles, uniform internal geometry and enhanced surface finishes to increase load carrying capacity
Quick facts
- Part: Timken HA590253 wheel bearing and hub assembly
- Fits: 2007-2018 Nissan Altima and other vehicles
- Position: Front, rear
- Condition: New
A hum or growl that changes with speed, vibration or a loose feel at the wheel can mean a worn bearing, but tires and brake parts cause similar symptoms. If a service has the wheel off, look at the seal for grease leaks, and let a shop test anything unclear before you replace the assembly. This listing is one assembly; both sides of an axle are normally replaced together.
Fits
It is a direct-fit replacement for a wide range of Nissan and Infiniti models, led by the 2007-2018 Nissan Altima, the 2016-2023 Nissan Maxima and the 2013-2020 Nissan Pathfinder.
Specifications
Fit and size
- Position: front, rear
- Quantity per vehicle: 2
- Wheel studs: 5
- Flange bolt holes: 4
- Bolt circle diameter: 114.30 mm (4.500 in)
- Flange diameter: 148.00 mm (5.827 in)
- Flange offset: 69.00 mm (2.717 in)
- Hub pilot diameter: 84.00 mm (3.307 in)
- Brake pilot diameter: 68.00 mm (2.677 in)
- Wheel pilot diameter: 66.00 mm (2.598 in)
Build and materials
- Drive type: non-driven
- ABS sensor: 100% tested to monitor wheel speed for the anti-lock braking system
- Condition: new
In the box
One wheel bearing and hub assembly; the car takes two in total.
Installation notes
- Supplied preset, pre-greased and pre-sealed.
Interchange: 051-6347
WE60522 · 512388 · 512389 · BR930698
This part cross-references / interchanges with the following part numbers:
WE60522, 051-6347, 512388, 512389, BR930698
Frequently Asked Questions
Is Timken HA590253 the right wheel bearing for a 2007-2018 Nissan Altima?
Yes. Timken HA590253 is listed for the 2007-2018 Nissan Altima, the 2016-2023 Nissan Maxima and the 2013-2020 Nissan Pathfinder. If your car isn't named here, look it up in the "Vehicles it fits" section.
Are these Timken wheel hubs driven or non-driven?
Non-driven. Timken HA590253 is non-driven, with 5 wheel studs and 4 flange bolt holes.
What are the bolt circle and pilot sizes of Timken HA590253?
Bolt circle is 114.30 mm (4.500 in), wheel pilot 66.00 mm, hub pilot 84.00 mm and brake pilot 68.00 mm. The flange is 148.00 mm across.
Can I keep driving with a humming wheel bearing?
No. Have the wheel checked and the bearing replaced promptly; a shop can confirm whether the hum comes from the bearing.
Is this Timken wheel bearing and hub assembly pre-greased?
Yes. Timken HA590253 is supplied preset, pre-greased and pre-sealed.
