Timken HA590431 rear wheel bearing and hub assembly for the 2011-2014 Mazda 2 supports the rear wheel and lets it turn. The Timken wheel bearing arrives preset, pre-greased and pre-sealed.
- Low runout to reduce noise and vibration at the wheel, which supports braking performance
- Seals with a reinforced outer case, a ribbed rubber inner diameter and a contamination exclusion system
- Seal vent holes that prevent installation damage and promote positive sealing
- Bearings with precision profiles, uniform internal geometry and enhanced surface finishes to raise load carrying capacity and extend bearing life
Quick facts
- Part: Timken HA590431 wheel bearing and hub assembly
- Fits: 2011-2014 Mazda 2
- Position: Rear
- Condition: New
A worn rear hub bearing can show up as a humming or growling noise that changes with speed, or as vibration from the back of the car. Before you replace the hub unit, rule out a tire, wheel balance or brake problem that makes similar noises.
Fits
This rear unit is a direct-fit replacement for the 2011-2014 Mazda 2. Timken controls the design, materials and manufacturing process of its hub bearing assemblies through OE-developed tests.
Specifications
Fit and size
- Position: Rear
- Quantity per vehicle: 2
- Drive type: Non-driven
- Bolt circle diameter: 100.00 mm (3.937 in), 4 bolt holes
- Wheel studs: 4
- Flange diameter: 121.8 mm (4.795 in)
- Flange offset: 68.50 mm (2.696 in)
- Hub pilot diameter: 64.50 mm (2.539 in)
- Brake pilot diameter: 55.00 mm (2.165 in)
- Wheel pilot diameter: 54.00 mm (2.125 in)
Build and materials
- Construction: preset, pre-greased and pre-sealed hub unit
- ABS sensor: 100% tested to monitor wheel speed for anti-lock braking systems
- Condition: New
In the box
One rear wheel bearing and hub assembly. The 2011-2014 Mazda 2 takes two, so order two Timken hub bearings and fit them together.
Interchange: 406.45007
512468 · BR930832
This part cross-references / interchanges with the following part numbers:
406.45007, 512468, BR930832
Frequently Asked Questions
Do these Timken wheel hubs fit the 2011-2014 Mazda 2?
Yes. Timken HA590431 is a rear, non-driven hub unit made for the 2011-2014 Mazda 2.
Is the rear Timken HA590431 hub driven or non-driven?
It is non-driven, with 4 wheel studs and 4 flange bolt holes on a 100.00 mm (3.937 in) bolt circle.
What are the pilot sizes on the Timken wheel bearing and hub assembly?
This rear hub unit has a 64.50 mm (2.539 in) hub pilot, a 55.00 mm (2.165 in) brake pilot and a 54.00 mm (2.125 in) wheel pilot.
How are the seals built on the Timken HA590431 hub unit?
Timken HA590431 has seals with a reinforced outer case, a ribbed rubber inner diameter, a contamination exclusion system and vent holes that prevent installation damage.
Can this Timken wheel bearing assembly be used where 512468 is listed?
Yes. 512468 is an interchange number for this rear hub unit, along with 406.45007 and BR930832.
