Rear Wheel Bearing and Hub Assembly for 2011-2016 Honda CR-Z - Timken HA590434

$191.99

Timken Wheel Bearing and Hub Assembly HA590434

Timken Wheel Bearing and Hub Assembly HA590434 - view 2

Timken Wheel Bearing and Hub Assembly HA590434 - view 3

Timken Wheel Bearing and Hub Assembly HA590434 - view 4

Part number: HA590434

UPC: 085706024758

Condition: New

Weight: 5.50 LBS

Item Package Quantity: 1

$191.99

Current Stock: 9

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Timken Wheel Bearing and Hub Assembly P/N:HA590434

$191.99

Description

Timken HA590434 rear wheel bearing and hub assembly for the 2011-2016 Honda CR-Z lets the rear wheel turn smoothly on its axle. This Timken wheel bearing is built into the hub unit, so bearing and hub are replaced as one piece.

Preset, pre-greased and pre-sealed hub unit bearing assembly
Low runout helps reduce noise and vibration for a smoother ride
Seals with a reinforced outer case, ribbed rubber inner diameter, contamination exclusion system and vent holes against installation damage
Timken hub bearings have precision profiles, uniform internal geometry and enhanced surface finishes for higher load capacity

Quick facts

Part: Timken HA590434 wheel bearing and hub assembly
Fits: 2011-2016 Honda CR-Z
Position: Rear
Condition: New

A worn hub bearing can show up as a hum or growl from the rear, vibration or an ABS light. Uneven tire wear, a worn brake rotor or a faulty ABS sensor can be behind those signs too, so find the cause before buying.

Fits

It fits the 2011-2016 Honda CR-Z, which takes two, one on each side of the rear axle. Replacing the pair together is the usual advice, and this listing is one unit.

Specifications

Fit and size

Position: Rear
Quantity per vehicle: 2
Drive type: Non-driven
Wheel studs: 5
Bolt circle diameter: 114.30 mm (4.500 in)
Brake pilot diameter: 64 mm (2.519 in)
Hub pilot diameter: 77.6 mm (3.055 in)
Wheel pilot diameter: 58.00 mm (2.283 in)
Flange diameter: 139.00 mm (5.472 in)
Flange offset: 56.00 mm (2.204 in)

Build and materials

Construction: hub unit bearing assembly, preset, pre-greased and pre-sealed
Condition: New

Interchange: 512481 · BR930833

Manufacturer's description

Product specs

Vehicles it fits

Interchange numbers

This part cross-references / interchanges with the following part numbers:

512481, BR930833

Buyer's Q&A

Frequently Asked Questions

Does this Timken wheel bearing assembly fit the 2011-2016 Honda CR-Z?

Yes. Timken HA590434 is a rear unit for the 2011-2016 Honda CR-Z, and the car takes two, one on each side of the rear axle.

What is the bolt circle on these Timken wheel hubs?

This rear hub has a bolt circle of 114.30 mm (4.500 in) and five wheel studs. It is a non-driven unit.

Does the Timken wheel bearing and hub assembly come pre-greased?

Yes. Timken HA590434 is supplied preset, pre-greased and pre-sealed.

How can I tell a rear hub bearing is wearing out?

A hum or growl that rises with speed, vibration or an ABS warning light can mean it is. A shop can confirm the bearing, since checking it needs the wheel raised.

Does Timken HA590434 replace 512481?

Yes. 512481 is a listed interchange number for this Timken rear hub assembly.