Front Wheel Bearing and Hub Assembly for 2011-2016 Ford F-450 Super Duty - Timken HA590440

Timken HA590440 front wheel bearing and hub assembly for the 2011-2016 Ford F-450 Super Duty lets the wheel turn on the axle. This Timken wheel bearing is built into the hub, so the bearing and hub are replaced as one unit.

• Preset, pre-greased and pre-sealed hub unit assembly
• Testing controls the design, materials and manufacturing process of Timken wheel hubs
• Low runout helps reduce noise and vibration and can improve braking performance
• Seals have a reinforced outer case, ribbed rubber inner diameter, contamination exclusion system and vent holes to prevent installation damage
• Timken hub bearings have precision profiles, uniform internal geometry and enhanced surface finishes to raise load capacity and extend bearing life

Quick facts

• Part: Timken HA590440 wheel bearing and hub assembly
• Fits: 2011-2016 Ford F-450 Super Duty
• Position: Front
• Condition: New

A worn hub bearing can show up as a hum or growl that changes with speed, vibration, or play at the wheel. Before you replace this assembly, rule out tire wear, wheel balance and brake or suspension problems that can cause similar noise and vibration.

Fits

It fits the 2011-2016 Ford F-450 Super Duty, which takes two, one for each front wheel. This listing is a single assembly, and the other side of that axle is normally done at the same time.

Specifications

Interchange: WE60623 · 515134 · BR930883