Timken Wheel Bearing and Hub Assembly P/N:HA590559
$210.99
(You save)
Restore quiet, smooth wheel-end operation on your Nissan with the Timken Wheel Bearing and Hub Assembly HA590559, a preset, pre-greased and pre-sealed hub unit that drops in as a direct-fit replacement for the 2009-2014 Nissan Murano [All] and 2011-2017 Nissan Quest [All].
Premium sealing: reinforced outer seal case, ribbed rubber inner diameter, a contamination-exclusion system, and vent holes to help prevent installation damage while promoting positive sealing.
Precision bearings: precision profiles, uniform internal geometry, and enhanced surface finishes designed to increase load-carrying capacity, extend bearing life, and help improve fuel economy.
Integrated ABS sensor: 100% tested to monitor wheel speed for the anti-lock braking system (ABS).
Low runout: helps reduce noise and vibration and supports braking performance.
Timken uses OE-developed tests to control the design, materials, and process behind its hub bearing assemblies. Key specs include a 5-stud flange, 32-spline bore, 4-bolt mounting flange, and a 114.30 mm (4.500 in) bolt circle. A humming or growling that changes with speed, wheel play, or an illuminated ABS light can be signs this hub bearing may need replacing; diagnose the cause before replacing. This listing is for one assembly; the listed applications use two per vehicle, so order two to do both sides.
Manufacturer part number HA590559
This part cross-references / interchanges with the following part numbers:
513338, BR930767
Frequently Asked Questions
Which vehicles does the Timken HA590559 fit?
It's a direct-fit replacement for the 2009-2014 Nissan Murano [All] and 2011-2017 Nissan Quest [All]. See the Buyer's Guide tab to confirm your vehicle.
Does this hub assembly include an ABS sensor?
Yes. It features an integrated ABS sensor that Timken 100% tests to monitor wheel speed for the anti-lock braking system.
How many hub assemblies do I need?
This listing is for one assembly. The listed Murano and Quest applications use two per vehicle, so order two if you're replacing both sides.
What are signs this hub bearing may need replacing?
A humming or growling that changes with speed, wheel play or looseness, or an illuminated ABS light can be signs. Diagnose the cause before replacing.
Does it need to be packed with grease before installing?
No. It's a preset, pre-greased and pre-sealed hub unit bearing assembly, so no adjustment or repacking is required.
Write a Review
Timken
Timken Wheel Bearing and Hub Assembly P/N:HA590559
Hub Unit Bearing Assemblies: Preset, Pre-Greased And Pre-SealedTimken Uses Oe-Developed Tests Controling The Design, Materials And Process Used To Manufacture Their Hub Bearing Assemblies, Ensuring...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
