Timken Wheel Bearing and Hub Assembly P/N:HA590651
$234.99
(You save)
Keep the rear wheels rolling quiet and true with the Timken Wheel Bearing and Hub Assembly HA590651, a preset, pre-greased and pre-sealed hub unit that drops in as a direct-fit replacement for the rear position on the 2016-2025 Mazda MX-5 Miata [All]. Timken designs, sources and manufactures its hub bearing assemblies using OE-developed tests that control materials and process for consistent performance.
Smoother, quieter ride: Low runout helps reduce noise and vibration while supporting braking performance.
Premium seals: A reinforced outer case, ribbed rubber inner diameter and contamination-exclusion system, plus vent holes to prevent installation damage, promote positive sealing and enhance seal life.
Premium bearings: Precision profiles, uniform internal geometry and enhanced surface finishes increase load-carrying capacity and extend bearing life.
Integrated ABS sensor: 100% tested to monitor wheel speed for anti-lock braking systems.
Signs this rear hub assembly may need replacing include a humming or growling wheel-end noise, play or roughness when the wheel is spun, or an ABS warning light. The Miata uses two rear hubs, so this assembly is sold individually; order 2 to service both sides for balanced results.
Interchange: 513642 · BR930971
This part cross-references / interchanges with the following part numbers:
513642, BR930971
Frequently Asked Questions
Does this hub fit my Mazda MX-5 Miata?
It is a direct-fit rear Wheel Bearing and Hub Assembly for the 2016-2025 Mazda MX-5 Miata [All]. Check the Buyer's Guide tab to confirm your vehicle.
Which axle position is this for?
This is the rear hub assembly. Each Miata uses two, so order 2 if you plan to service both rear wheels.
Is it greased and sealed already?
Yes. It is a preset, pre-greased and pre-sealed hub unit bearing assembly, ready to install.
Does it include an ABS sensor?
Yes. It features an ABS sensor that is 100% tested to monitor wheel speed for anti-lock braking systems.
What are signs this hub needs replacing?
Common signs include a humming or growling noise from the wheel, play or roughness when spinning the wheel, or an ABS warning light. Diagnose the cause before replacing.
Write a Review
Timken
Timken Wheel Bearing and Hub Assembly P/N:HA590651
Hub Unit Bearing Assemblies: Preset, Pre-Greased And Pre-SealedTimken Uses Oe-Developed Tests Controling The Design, Materials And Process Used To Manufacture Their Hub Bearing Assemblies, Ensuring...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
