Keep a unitized wheel bearing locked securely in the front knuckle with the Timken Wheel Bearing Retaining Ring RET176. This clip is used to secure a unitized bearing to the knuckle, and it drops in as a direct-fit replacement for the 2003-2006 Subaru Baja, 1998-2008 Subaru Forester, 1993-2007 Subaru Impreza, 1990-2004 Subaru Legacy, 2000-2004 Subaru Outback, and 1988-1991 Subaru XT. See the Buyer's Guide tab for engine-level details.
Engineered to OEM specifications: built to match the original ring's job of holding the bearing in place.
Secure fit without scoring: designed to seat firmly without scoring the inside of the bore.
Universal design for easier installation: reduces notch configurations for simpler service.
Optimized notch access: notches are set for optimum access using traditional snap ring pliers.
Aligned with stringent Timken quality standards, this retaining ring is a small but critical component — if the original clip is worn, distorted, or was damaged during bearing service, replacing it helps keep the front bearing properly located in the knuckle. Signs the clip may need replacing include a ring that no longer seats fully in its groove or shows deformation.
Interchange: CIR176
This part cross-references / interchanges with the following part numbers:
CIR176
Frequently Asked Questions
What does the Timken RET176 retaining ring do?
It is a clip used to secure a unitized wheel bearing to the knuckle, keeping the front bearing properly located in its bore.
Which vehicles does the RET176 fit?
It fits the 2003-2006 Subaru Baja, 1998-2008 Forester, 1993-2007 Impreza, 1990-2004 Legacy, 2000-2004 Outback, and 1988-1991 XT. Check the Buyer's Guide tab for details.
Is this a front or rear part?
This retaining ring is cataloged for the front position, securing the unitized bearing to the front knuckle.
What tool is used to install it?
Its notches are set for optimum access using traditional snap ring pliers, and the universal design reduces notch configurations for easier installation.
What number does this ring cross-reference?
The RET176 interchanges with CIR176. Confirm fitment for your specific vehicle before ordering.
Clip Used to Secure Unitized Bearing to KnuckleEngineered To Oem SpecificationsProvide A Secure Fit Without Scoring The Inside Of The BoreProvide Ease Of Installation With A Universal Design That...
Clip Used to Secure Unitized Bearing to KnuckleEngineered To Oem SpecificationsProvide A Secure Fit Without Scoring The Inside Of The BoreProvide Ease Of Installation With A Universal Design That...
Lock the front unitized wheel bearing securely into the steering knuckle with the Timken Wheel Bearing Retaining Ring RET188. This snap-style clip holds the pressed-in front hub bearing in its...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
