Keep the right-side CV axle shaft properly supported with the TrakMotive CV Axle Shaft Carrier Bearing Bracket TO-5006 (also written TO5006). It installs as a direct-fit replacement for the 2013-2018 Toyota RAV4 — see the Buyer's Guide tab for the engine-level applications.
The carrier bearing bracket mounts the intermediate shaft's support bearing to the vehicle, holding the shaft in its intended position between the transaxle and the outer CV joint. A cracked, corroded, or loose bracket can let the shaft move under load, so replacing a worn bracket with this unit restores the correct support point if the original mount is the cause of your vibration or clunk.
Inspect the shaft, support bearing, and surrounding hardware during installation, and consult the vehicle service information for the correct fasteners and whether they may be reused.
This part cross-references / interchanges with the following part numbers:
What does this carrier bearing bracket do?
It mounts the CV axle's intermediate shaft support bearing to the vehicle, holding the shaft in its intended position between the transaxle and the outer CV joint.
Which vehicles does the TO-5006 fit?
It is a direct-fit replacement for the 2013-2018 Toyota RAV4. Check the Buyer's Guide tab to confirm the application for your vehicle.
Which side is this bracket for?
This bracket is for the RIGHT side.
What are signs the bracket may need replacing?
A cracked, corroded, or loose bracket can allow the shaft to move under load, which may show up as vibration or a clunk. Diagnose the cause before replacing.
Is there a warranty?
Yes. This TrakMotive bracket carries a Limited Lifetime Warranty and is built by an ISO 9001:2008 and TS 16949:2009 certified company.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
