TrakMotive NI-8099XTT front CV axle shaft for the 1998-2004 Nissan Frontier and other vehicles carries drive power to the wheel. This TrakMotive CV axle is an Extended Travel design.
Clicking or popping on turns, grease thrown around the joint or a torn boot can mean a CV axle shaft is wearing. Other parts can make similar noises, so with the engine off, look over the boots and joints for tears or flung grease and find the cause before replacing the shaft.
Besides the 1998-2004 Nissan Frontier, it fits the 2010-2011 Nissan NP300 and the 2000-2004 Nissan Xterra. This listing is one shaft for the front left; the other side of that axle is a separate part and is normally replaced at the same time.
Fit and size
Build and materials
One CV axle shaft. The axle nut is not included, so plan on a new one, since the old nut may not be reusable. The 1998-2004 Nissan Frontier and the 2000-2004 Nissan Xterra list a quantity of two per vehicle, and the 2010-2011 Nissan NP300 lists one.
Interchange: 40-18387 · 80-5440 · 60-6193 · NI-8387 · 80-4707 · NI-8-8554 · AX-2698
411011 · 801011 · 650740 · 9700 · CV3836 · NCV53133XDP · 93880 · 95440 · CV3393 · 702698
This part cross-references / interchanges with the following part numbers:
Does this TrakMotive CV axle shaft fit the 2000-2004 Nissan Xterra?
Yes. TrakMotive NI-8099XTT fits the 2000-2004 Nissan Xterra as a front left shaft, and that fitment lists a quantity of two.
Does the NI-8099XTT come with an axle nut?
No. TrakMotive NI-8099XTT is one CV axle shaft, and the axle nut is not included. The ABS tone ring is not included either.
How many splines does the outboard end of this CV axle shaft have?
The outboard joint is a male end with 28 splines. The inboard end of this front CV axle shaft is a flange joint with 6 bolt holes.
How can I tell if the boots on my front CV axle shaft are failing?
A torn thermoplastic boot, grease thrown around the joint or clicking on turns can mean the joint is wearing. A shop can test the joint further.
How much extra travel does the TrakMotive NI-8099XTT Extended Travel axle give?
The sliding center bar gives up to 44mm more travel than an OEM CV shaft. The CV joints reach up to 47 degrees of articulation, against 23 degrees on a typical OE joint.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
