Walker Products Oxygen Sensor P/N:350-34354
Give your engine computer an accurate read on exhaust oxygen with the Walker Products 350-34043 Oxygen Sensor. This 4-wire, direct-fit, narrow-band sensor measures combustion efficiency from the amount of oxygen in the exhaust gas. It fits many vehicles, among them the 1998-2001 Chevrolet Metro, 1998-2000 Chevrolet Tracker and 1995-2000 Pontiac Firefly. See the Buyer's Guide tab for the full list.
Walker Products developed its engine management and oxygen/air-fuel sensors as OE replacements. Each part number is built for its specific application and fitment position, so it provides the diagnostic feedback the ECU requires. This sensor is cataloged for upstream and downstream positions.
A failed oxygen sensor may cause the engine to run poorly or raise fuel consumption and exhaust emissions. It may also turn on the malfunction indicator light (MIL), and newer vehicles may store related fault codes in the ECU. If the sensor is the cause, this unit replaces it. Walker also advises checking the sensor, wiring harness and connector for physical damage.
This Walker Products oxygen sensor comes from a company that has supplied engine management sensors and fuel system components since 1946. Walker Products is an ISO 9001/TS 16949 certified company.
Will this Tracker sensor fit my 1998-2000 Chevrolet Tracker?
Yes, the Walker Products 350-34043 is listed as a direct-fit application for the 1998-2000 Chevrolet Tracker. Use the Buyer's Guide tab to confirm your exact vehicle.
What does this oxygen sensor do?
It measures the oxygen content of the exhaust gas. The engine computer uses that reading to monitor the air-fuel ratio and fine-tune the mixture for combustion efficiency.
What type of sensor is the 350-34043?
It is a 4-wire, narrow-band, direct-fit oxygen sensor. It has gas-permeable platinum electrodes and a coating that helps protect them from combustion residue and particulates.
What are signs an oxygen sensor may need replacing?
Possible signs include poor engine running, higher fuel consumption, increased emissions or a lit malfunction indicator light. Diagnose the cause before replacing the sensor.
Should I check anything else when installing it?
Yes. Walker advises checking the sensor, wiring harness and connector for physical damage, so inspect the harness and connector along with the sensor itself.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.