Walker Products 350-35016 oxygen sensor for the 2010 Ford Fusion V6 3.0L or 3.5L and other vehicles measures the oxygen content of the exhaust gas. This Walker Products oxygen sensor is made for its specific application and fitment position, and it gives the ECU the diagnostic feedback it needs.
- Measures oxygen in the exhaust gas to monitor the air-fuel ratio for combustion efficiency
- Electrodes made of a gas-permeable platinum layer
- Monitors exhaust gases and helps reduce pollutants
- Measures oxygen levels so the air-fuel mixture can be fine-tuned, which helps fuel economy
- Coating protects the electrode surfaces from contamination and erosion by combustion residue and particulates
Quick facts
- Part: Walker Products 350-35016 oxygen sensor
- Fits: 2010 Ford Fusion V6 3.0L or 3.5L and other vehicles
- Position: Upstream, upstream front, upstream rear
- Condition: New
A failing sensor can show up as poor engine running, higher fuel consumption, more exhaust emissions or a lit malfunction indicator light. Those signs alone do not prove the sensor is the problem, because a fault in the wiring or connector can look the same. With the engine off and cool, check the sensor, wiring harness and connector for physical damage. This listing is one sensor, and the fitment calls for a single unit.
Fits
As a 2010 Ford Fusion oxygen sensor replacement for the V6 3.0L or 3.5L, it is a direct fit, and the vehicles it covers also include the 2009-2010 Mazda 6 V6 3.7L and, as a Mitsubishi Mirage oxygen sensor, the 2014 model with the 3-cylinder 1.2L. For any other car, look it up in the "Vehicles it fits" section to see if it is covered.
Specifications
Fit and size
- Position: upstream, upstream front, upstream rear
- Quantity per vehicle: 1
- Thread size: M18 - 1.5
Build and materials
- Type: wide-band
- Electrodes: gas-permeable platinum layer
- Condition: New
Frequently Asked Questions
Is this the right 2010 Ford Fusion oxygen sensor for the V6 3.0L or 3.5L?
Yes. Walker Products 350-35016 fits the 2010 Ford Fusion with the V6 3.0L or the V6 3.5L, and each of those engines takes one sensor.
Does this work as a 2009-2010 Mazda 6 oxygen sensor with the V6 3.7L?
Yes. This sensor fits the 2009-2010 Mazda 6 V6 3.7L, and that engine takes one.
What thread size does the Walker Products 350-35016 have?
Walker Products 350-35016 has an M18 - 1.5 thread and is a wide-band oxygen sensor.
How can I tell if an upstream oxygen sensor is going bad?
A failing oxygen sensor can make the engine run poorly, raise fuel use and emissions, or light the malfunction indicator. Newer vehicles also store fault codes in the ECU, which a shop can read.
What protects the electrodes on this oxygen sensor?
A coating protects the electrode surfaces from contamination and erosion by combustion residue and particulates in the exhaust. The electrodes themselves are made of a gas-permeable platinum layer.
