Timken HA590125 front wheel bearing and hub assembly for the 2014-2024 Infiniti Q50 and other vehicles supports the front wheel and lets it turn on the axle. As a Timken wheel bearing, it is built into the hub, so the bearing and hub flange are replaced as one piece.
- Hub unit bearing assembly arrives preset, pre-greased and pre-sealed
- Design, materials and manufacturing process are controlled through testing for consistent performance
- Low runout helps reduce noise and vibration
- Seals with reinforced outer case, ribbed rubber inner diameter, contamination exclusion system and vent holes
- Bearings with precision profiles, uniform internal geometry and enhanced surface finishes to raise load capacity
Quick facts
- Part: Timken HA590125 wheel bearing and hub assembly
- Fits: 2014-2024 Infiniti Q50 and other vehicles
- Position: Front
- Condition: New
A growl or hum that rises with road speed, vibration, or looseness at the wheel can mean this assembly is worn, though a tire or a brake rotor can cause similar noise and vibration, so pin down which it is before ordering.
Fits
This front wheel bearing and hub assembly is made for the 2014-2024 Infiniti Q50, the 2017-2022 Infiniti Q60, the 2014-2019 Infiniti Q70 and other Infiniti models. The 2014-2024 Infiniti Q50 takes two. This listing is one front unit, and the other side of that axle is normally done at the same time.
Specifications
Fit and size
- Position: Front
- Quantity per vehicle: 2
- Bolt circle diameter: 114.30 mm (4.500 in)
- Wheel studs: 5
- Flange bolt holes: 4
- Flange diameter: 136.00 mm (5.354 in)
- Flange offset: 40.65 mm (1.600 in)
- Hub pilot diameter: 92.96 mm (3.660 in)
- Brake pilot diameter: 67.95 mm (2.675 in)
- Wheel pilot diameter: 65.96 mm (2.597 in)
- Spline quantity: 27
Build and materials
- Drive type: Driven
- Condition: New
Interchange: 051-6243 · 400.42001
WE61813 · 513335 · BR930892
This part cross-references / interchanges with the following part numbers:
WE61813, 051-6243, 400.42001, 513335, BR930892
Frequently Asked Questions
Will this Q50 wheel bearing fit a 2014-2024 Infiniti Q50?
Yes. Timken HA590125 is a front wheel bearing and hub assembly listed for the 2014-2024 Infiniti Q50. Owners of another Infiniti can look up their car in the "Vehicles it fits" section.
Are Timken wheel hubs like this one sold singly?
Yes. This Timken HA590125 listing is one front unit, and the other side of the axle is a separate part.
What is the bolt circle on these Timken front wheel bearings?
The HA590125 has a 114.30 mm (4.500 in) bolt circle with five wheel studs, and its brake pilot diameter is 67.95 mm (2.675 in).
Is a Timken wheel bearing and hub assembly like this preset and greased?
Yes. This unit comes preset, pre-greased and pre-sealed, and its seals have vent holes that prevent installation damage.
Does the 513335 number cross to this Timken unit?
Yes. 513335 is one of the numbers that Timken HA590125 replaces.
