Replace swollen, hard-to-remove factory lug nuts with the Dorman wheel lug nut 611-930.1. This OE FIX replacement swaps the original two-piece construction for a one-piece carbon steel design. It fits many vehicles, among them the 2023-2025 Ford E-Transit, 2017-2025 Ford F-250 Super Duty and 2017-2025 Ford F-350 Super Duty. See the "Vehicles it fits" section for the full list.
On certain vehicles, the original lug nuts use a two-piece design that often fails, so warping and difficult removal are common. A thin veneer can be damaged with repeated use, and moisture trapped under it can make the cover bulge. A nut in that condition can become difficult or impossible to remove, and freeing a stuck one usually means damaging the wheel. Dorman built this replacement to match the OE fit and function, and its one-piece carbon steel design is intended to help prevent the same problems from returning.
- Improved design: a direct-replacement, one-piece lug nut instead of the two-piece factory design that often leads to premature failure of the wheel nut.
- Corrosion resistant: without the veneer used on the OEM lug nut design, there is no layer for moisture and rust to get under and cause the nut to bulge and deform.
- Thoroughly tested: proof load, salt spray, hardness and thread check testing to meet strict standards.
- Quality engineering: designed in the United States and backed by decades of automotive aftermarket experience.
Specifications: M14-1.50 thread, flanged, 21mm hex, 48.5mm length.
Interchange: HCPZ1012A · HCPZ1012B
Frequently Asked Questions
Which vehicles does this lug nut fit?
It fits many vehicles, including the 2023-2025 Ford E-Transit, 2017-2025 Ford F-250 Super Duty and 2017-2025 Ford F-350 Super Duty. The "Vehicles it fits" section lists every application.
Why replace a two-piece factory lug nut with this Dorman Autograde wheel lug nut?
The original two-piece design has a thin veneer that can be damaged and bulge if moisture gets under it, which makes removal difficult. This one-piece carbon steel design has no veneer.
What are the thread and hex sizes of this Dorman wheel nut?
It has an M14-1.50 thread and a 21mm hex. It is a flanged design with a 48.5mm length.
How are these Dorman lug nuts tested?
Dorman put this part through proof load, salt spray, hardness and thread check testing to meet strict standards.
What should I know when installing Dorman Autograde lug nuts?
Start each nut by hand to avoid cross-threading. Then tighten it in the recommended pattern to the torque value in your vehicle's service information.
