Anchor Drive Shaft Center Support Bearing P/N:6074
$59.99
(You save)
Quiet a vibrating driveline and keep a two-piece driveshaft properly supported with the Anchor Drive Shaft Center Support Bearing 6074. It installs as a direct-fit replacement for the 1993-1998 Toyota T100, 1995-2015 Toyota Tacoma, and 2000-2021 Toyota Tundra (all engines), sitting between the transmission and differential to support the driveshaft and relieve stress on driveline components.
Vibration damping: a rubber cushion of natural and Styrene Butadiene rubber dampens vibration and helps absorb overloads, while resisting wear and staying stable as it ages.
Strong rubber-to-metal bond: a Chemlock bonding agent locks the rubber to the metal.
Sealed bearing: a sealed, round bearing comes ready to install.
Heavy-gauge steel housing: a durable steel frame carries the assembly.
Engineered to OE standards, it measures a 30 mm (1.1811 in) inside diameter with 152 mm (6 in) bolt-hole center-to-center spacing and a 13 mm (0.5 in) center line to mounting surface. Any included fasteners are hardened, heat-treated Grade-5 bolts. Grade type: Standard Replacement. Country of origin: China. Backed by a 12-month warranty.
Interchange: Manufacturer part number 6074.
This part cross-references / interchanges with the following part numbers:
What does the Anchor 6074 center support bearing do?
It supports the driveshaft between the transmission and differential and relieves stress on driveline components, while its rubber cushion helps dampen vibration.
Which vehicles does it fit?
It's a direct-fit replacement for the 1993-1998 Toyota T100, 1995-2015 Toyota Tacoma, and 2000-2021 Toyota Tundra (all engines). Check the Buyer's Guide tab to confirm your vehicle.
Is the bearing sealed?
Yes. The catalog lists it as a sealed, round bearing that comes ready to install.
What are signs this part may need replacing?
Driveline vibration, humming or growling that changes with speed, or clunking can be signs. Have the cause diagnosed, as these symptoms can come from other driveline parts too.
What are its key dimensions?
It has a 30 mm (1.1811 in) inside diameter, 152 mm (6 in) bolt-hole center-to-center spacing, and a 13 mm (0.5 in) center line to mounting surface. Country of origin: China.
Write a Review
Anchor
Anchor Drive Shaft Center Support Bearing P/N:6074
Keep your driveshaft spinning smoothly and quietly with the Anchor Drive Shaft Center Support Bearing 6076. This center support mounts the driveshaft between the transmission and differential,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
