Beck/Arnley CV Joint Boot Kit P/N:103-3033
Seal out grit and keep the axle grease where it belongs with the Beck/Arnley CV Joint Boot Kit 103-2926. This kit services the front inner (front right inner) CV joint and drops in as an application-specific replacement for the 1999-2000 and 2003-2005 Honda Civic. Beck/Arnley sources parts to match OE form, fit, and function for foreign-nameplate applications, so it's built to reseal the joint the way the factory boot did — see the Buyer's Guide tab for engine-level fitment.
A torn or cracked CV boot lets grease sling out and lets dirt and moisture into the joint. If a failed boot is the cause of clicking on turns or grease around the inner joint, replacing it early can protect the CV joint from further wear.
Interchange: 862346 · 44017S01A21 · 44017S5DA10 · 668052 · DX630 · 8168072
This part cross-references / interchanges with the following part numbers:
What position does this boot kit fit?
It services the front inner (front right inner) CV joint on the listed Honda Civic applications.
What vehicles does the 103-2926 kit fit?
It is an application-specific fit for the 1999-2000 and 2003-2005 Honda Civic. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
What comes in the kit?
The kit includes the boot, grease, and clamps. The supplied grease contains an extreme-pressure additive for the CV joint's contact surfaces.
When should I replace a CV boot?
Signs a boot may need replacing include cracks or tears, grease slung around the inner joint, or clicking on turns. Diagnose the cause before ordering.
Can I use any install tool to fit the boot?
This kit is not intended for installation tools that stretch the small end of the boot over the CV joint. Follow the vehicle service procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.