Beck/Arnley Steering Tie Rod End P/N:101-6810
Keep your steering tight and predictable with the Beck/Arnley Steering Tie Rod End 101-4571 — a front outer tie rod end that connects the steering linkage to the steering knuckle and transfers steering input to the wheel. It drops in as a direct replacement on many vehicles, among them the 2002-2006 Nissan Altima, 1995-2008 Nissan Maxima and 1995-1998 Nissan 240SX; see the Buyer's Guide tab for the full list and engine details.
A worn tie rod end can produce loose or wandering steering, uneven front tire wear, and a clunk or play felt through the wheel. If a failed front outer tie rod end is the cause, the 101-4571 replaces it. Have the front end aligned after installation for correct toe settings.
Where is this tie rod end located?
It is the front outer tie rod end, connecting the outer steering linkage to the steering knuckle to transfer steering input to the wheel.
Is this the right tie rod for a 2002-2006 Nissan Altima?
Yes. It is listed for the 2002-2006 Nissan Altima, along with other Nissan and Infiniti models shown in the Buyer's Guide tab.
Is hardware included with this Beck/Arnley steering tie rod end?
Yes. The hardware needed for installation is included, and the tie rod end comes pre-greased and ready to install.
What are the signs this tie rod end may need replacing?
Loose or wandering steering, a clunk or play felt through the steering wheel, and uneven front tire wear can all be signs of a worn tie rod end.
Do I need an alignment after installing it?
Yes. Replacing a tie rod end changes toe settings, so have the front end aligned afterward for correct steering geometry and even tire wear.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.