Keep your steering tight and precise with the Beck/Arnley Front Inner Steering Tie Rod End (MPN 101-5788), a direct-fit Nissan Altima tie rod that drops into the 2007-2012 Nissan Altima. It transfers steering input from the linkage to the wheel, and a worn unit can cause loose or wandering steering, uneven tire wear, and clunking or play when turning. If a failed tie rod end is the source, this replaces it.
Because this is an inner tie rod end that installs as part of the steering linkage, replacing both sides together helps keep steering response even. After installation, have the front wheel alignment checked and set to specification.
Interchange: 45A1233 · 61242046 · 48521JA00A · NIA613 · TI69080 · EV800356 · ES4454 · MS30702 · JAR1202
This part cross-references / interchanges with the following part numbers:
Will this inner tie rod fit a 2007-2012 Nissan Altima?
It is a direct-fit replacement for the 2007-2012 Nissan Altima. Check the Buyer's Guide tab to confirm it matches your specific vehicle.
Is this a front or rear tie rod end?
This is a front inner tie rod end for the steering linkage on the listed applications.
Does this tie rod end come pre-greased?
Yes. The ball joint is pre-greased and ready to install right out of the box.
What are the signs I may need a new tie rod end?
Loose or wandering steering, uneven or accelerated tire wear, and clunking or play when turning can indicate a worn tie rod end. Diagnose the cause before replacing.
Do I need an alignment after installing this tie rod end?
Yes. Replacing a tie rod end changes toe settings, so have the front wheel alignment checked and set to specification afterward.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
