Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-4179
$66.99
(You save)
Bring the front-left upper corner of your Honda's suspension back to spec with the Beck/Arnley Control Arm with Ball Joint (P/N 102-4179) — a direct-fit Honda Civic control arm that drops into the 1988-1991 Honda Civic and 1988-1991 Honda CRX. This is the FRONT LEFT UPPER unit, so it locates the wheel and pivots the front suspension through its integrated ball joint. Beck/Arnley states it matches OE form, fit and function, giving you a clean, application-specific replacement for the original.
Complete assembly: the control arm comes with the ball joint for a complete installation.
OE-matched: engineered as a direct replacement for the original-equipment part across foreign nameplates, with attention to form, fit and function.
Hardware & bushings: new hardware and bushings included where applicable.
Application specific: built for the listed Honda applications.
Worn control arm bushings or a failing ball joint can produce clunking over the front suspension, wandering steering, or uneven tire wear. If the front-left upper control arm or its ball joint is the cause, this Beck/Arnley control arm replaces it. Diagnose the corner before ordering, and inspect the opposite side too.
It fits the 1988-1991 Honda Civic and the 1988-1991 Honda CRX. Check the Buyer's Guide tab to confirm the correct application for your exact vehicle.
What is a control arm and ball joint assembly?
It's a suspension arm that locates the wheel and pivots on an integrated ball joint, allowing the suspension and steering to articulate while holding the wheel in position.
Does the ball joint come with this part?
Yes. The control arm comes with the ball joint for a complete installation, so you replace both together as one assembly.
Will this work as one of the Crx upper control arms?
Yes. This is the front left upper unit and is listed for the 1988-1991 Honda CRX as well as the 1988-1991 Honda Civic.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and torque during installation.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-4179
Replace a worn Nissan Versa control arm and bring back steady, quiet handling with the Beck/Arnley Control Arm with Ball Joint (P/N 102-8296, also written 1028296). This front right lower control arm...
Keep the front wheel properly located and the steering knuckle pivoting freely with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-6818). This Nissan Sentra control arm drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
