Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5418
Replace a worn Nissan Versa control arm and its ball joint in one job with the Beck/Arnley Control Arm with Ball Joint 102-8296, a front right lower arm that is a direct-fit replacement for the 2020-2025 Nissan Versa, 2018-2024 Nissan Kicks and 2025 Nissan Kicks Play. The control arm connects the steering knuckle to the chassis. It lets the wheel travel up and down while holding it in position, and the ball joint is the pivot that lets the knuckle steer. Because the ball joint comes with the arm, both parts are replaced in a single installation.
Signs this Nissan Versa lower control arm may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear and play in the ball joint. Diagnose the cause first. If a worn arm or ball joint is to blame, this assembly replaces both.
This listing is for the front right lower arm. Replacing the left and right arms together is recommended. A wheel alignment is recommended after installation. See the Buyer's Guide tab for engine-specific fitment.
Interchange: 2703668222 · 545005RL1B · RK623798 · CMS301266
This part cross-references / interchanges with the following part numbers:
Will this fit my Nissan Versa?
Yes. It is a direct-fit front right lower arm for the 2020-2025 Nissan Versa. The Buyer's Guide tab shows the other listed vehicles and their engines.
Does this control arm and ball joint assembly include the ball joint?
Yes. The control arm comes with its ball joint, so you replace both in one installation and don't need to source the joint separately.
What makes the Beck/Arnley control arm a direct replacement?
Beck/Arnley designs it to match OE form, fit and function. It is application-specific for the listed vehicles in the front right lower position.
What are signs the lower control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear or play in the ball joint can indicate wear. Diagnose the cause first. If the arm or ball joint is worn, this replaces both.
Is a wheel alignment needed after installing it?
An alignment is recommended after replacing a control arm. Consult the vehicle service information for fastener torque and for whether the original fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.