Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-4332
$66.99
(You save)
Tighten up your suspension and steering geometry with the Beck/Arnley Control Arm and Ball Joint Assembly (P/N 102-4332), a direct-fit Honda Accord control arm for the 1990-1993 Honda Accord. This is the front right (passenger-side) upper unit, and it arrives with the ball joint installed so you replace both in one complete piece. If a worn control arm or ball joint is behind loose steering, uneven tire wear, or clunking over the front suspension, this assembly locates the wheel and lets it move through its travel.
Complete assembly: the control arm comes with the ball joint for a complete installation.
OE form, fit and function: engineered as a direct replacement for the original component on the listed applications.
Durable construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable.
Application-specific for this vehicle, this Beck/Arnley control arm is a straightforward Honda Accord upper control arm replacement. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Replace a worn Nissan Versa control arm and bring back steady, quiet handling with the Beck/Arnley Control Arm with Ball Joint (P/N 102-8296, also written 1028296). This front right lower control arm...
Keep the front wheel properly located and the steering knuckle pivoting freely with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-6818). This Nissan Sentra control arm drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
