Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5286
$193.99
(You save)
Sharpen steering response and control uneven tire wear with the Beck/Arnley Control Arm and Ball Joint Assembly 102-5286 — a direct-fit front left (driver's side) lower Nissan Altima control arm that also fits the Maxima. It drops in as an application-specific replacement for the 2002-2006 Nissan Altima and 2004-2008 Nissan Maxima (see the Buyer's Guide tab for engine-level fitment).
Complete assembly: the control arm comes with the ball joint for a complete installation, so you replace the arm, ball joint, and bushings in one unit.
OE-matched: designed as a direct replacement matching OE form, fit and function for foreign-nameplate applications.
Durable build: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable.
The lower control arm locates the front wheel and, through its integrated ball joint, allows the steering knuckle to pivot and travel. If a worn arm or ball joint is the cause of clunking over bumps, wandering steering, or uneven tire wear, this assembly replaces it. For balanced handling, inspect the opposite side at the same time.
What vehicles does this Beck/Arnley control arm fit?
It's an application-specific front left lower assembly for the 2002-2006 Nissan Altima and 2004-2008 Nissan Maxima. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Does this lower control arm for the Nissan Altima include the ball joint?
Yes. The control arm comes with the ball joint for a complete installation, and it includes new hardware and bushings where applicable.
Which position is this Nissan Maxima control arm?
It is the front left (driver's side) lower control arm and ball joint assembly for the listed applications.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking over bumps, wandering or loose steering, and uneven front tire wear. Diagnose the cause before replacing, since these symptoms can have other sources.
What is this control arm made of?
Per Beck/Arnley, it uses steel, iron, or aluminum construction for durability and rust/corrosion resistance, and is designed to match OE form, fit and function.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5286
CONTROL ARM WITH BALL JOINTBeck/Arnley parts are designed to be a direct replacement for Original Equipment (OE) applications across all foreign nameplates, with special attention given to form, fit,...
CONTROL ARM WITH BALL JOINTBeck/Arnley parts are designed to be a direct replacement for Original Equipment (OE) applications across all foreign nameplates, with special attention given to form, fit,...
Restore precise steering geometry and quiet the front suspension with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8166. This front left upper rearward assembly drops in as a...
Restore precise steering and quiet the front suspension with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-7724). This front left lower rearward unit combines the control...
Restore tight, predictable handling with the Beck/Arnley control arm and ball joint assembly (P/N 102-7778), a direct-fit replacement for the front right lower position on the 2006-2009 Subaru Legacy...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
