Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5465
$84.99
(You save)
Locate the front wheel and maintain proper steering geometry with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly, part number 102-5465. It installs as a direct-fit replacement in the front right upper position on the 2003-2006 Kia Sorento — see the Buyer's Guide tab for engine-level fitment. The control arm ships with its ball joint pre-installed for a complete installation, locating the suspension and allowing the knuckle to pivot through steering and travel.
Complete assembly: control arm comes with the ball joint, so you replace both wear points in one job.
OE-matched design: engineered to match OE form, fit, and function for the listed foreign-nameplate application.
Durable construction: steel, iron, or aluminum construction (varies by application) for durability and rust/corrosion resistance.
Application specific: new hardware and bushings included where applicable.
Signs this part may need replacing include clunking on acceleration, deceleration, or over bumps, uneven tire wear, and loose or wandering steering. If a worn upper control arm or ball joint is the cause, this assembly replaces it.
It is a direct-fit replacement for the 2003-2006 Kia Sorento in the front right upper position. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with the ball joint pre-installed for a complete installation, so both wear points are replaced together.
What position on the vehicle is this for?
This assembly is cataloged for the front right (passenger-side) upper position. It is sold individually for that corner.
What is the assembly made of?
Depending on the application, it uses steel, iron, or aluminum construction chosen for durability and rust/corrosion resistance.
What are the signs this part may need replacing?
Clunking on acceleration, deceleration, or over bumps, uneven tire wear, and loose or wandering steering can indicate a worn control arm or ball joint. Have the cause diagnosed before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5465
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
