Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6671
$152.99
(You save)
Restore precise wheel location and quiet, controlled handling with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6671). It drops in as a direct-fit replacement for the front left upper position on the 2001-2006 Lexus LS430 — see the Buyer's Guide tab for engine-level details. The control arm locates the wheel and helps support and guide suspension movement, while the integrated ball joint provides the pivoting connection between the arm and the steering knuckle; worn bushings or a loose ball joint can bring on clunking over bumps, wandering steering, or uneven tire wear that this assembly addresses when it is the cause.
Complete assembly: the control arm comes with its ball joint for a complete installation.
OE form, fit and function: engineered to replace the original equipment part on the listed application, with attention to form, fit, and function.
Durable construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Ready to install: new hardware and bushings included where applicable; this is an application-specific part for this vehicle.
Consult the vehicle service information for the correct fasteners and whether they may be reused.
This part cross-references / interchanges with the following part numbers:
10124123, 4863059035, RK641531, FA3388, CMS86195
Frequently Asked Questions
What vehicle does this control arm assembly fit?
It is a front left upper direct-fit replacement for the 2001-2006 Lexus LS430. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with its ball joint pre-installed for a complete installation, so you replace both components together.
What position is this assembly for?
This assembly is for the front left upper position. Order the matching part for other corners as needed.
What are signs this part may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to worn bushings or a loose ball joint. Diagnose the cause before replacing.
Is mounting hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6671
Keep your front suspension located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8368, cataloged for the front left lower position. It installs as...
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the rear suspension located and controlled with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7670, a rear left upper unit that installs as a direct replacement on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
