Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7371
$293.99
(You save)
Restore tight, precise handling on your Land Rover with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-7371). This front left lower control arm ships with its ball joint pre-installed for a complete corner replacement, and it drops in as a direct-fit application for the 2005-2009 Land Rover LR3 and 2010-2016 Land Rover LR4 (see the Buyer's Guide tab for the full engine breakdown). The control arm locates the wheel and lets the suspension travel, while the integrated ball joint pivots to allow steering and ride motion — worn examples can show clunking on acceleration, deceleration or over uneven pavement, uneven tire wear, and loose or wandering steering.
Matches OE form, fit and function as an OE-quality replacement across foreign-nameplate applications.
Arm and ball joint together for a complete installation at the corner.
Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
New hardware and bushings included where applicable.
Application-specific for the listed vehicles. If a failed original control arm or ball joint is the cause of your handling or noise concern, this assembly replaces it — diagnose the cause before ordering.
It's a direct-fit application for the 2005-2009 Land Rover LR3 and 2010-2016 Land Rover LR4. Check the Buyer's Guide tab to confirm the engine and configuration for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with the ball joint pre-installed for a complete corner replacement in a single assembly.
Which position is this control arm?
It's the front left lower control arm and ball joint assembly for the listed Land Rover applications.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking on acceleration, deceleration or over bumps, uneven tire wear, and loose or wandering steering. Diagnose the cause before replacing.
Is hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7371
Keep your front suspension located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8368, cataloged for the front left lower position. It installs as...
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the rear suspension located and controlled with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7670, a rear left upper unit that installs as a direct replacement on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
