Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5418
Help keep the front end steady and the wheel properly located with this Beck/Arnley control arm, part number 102-7656, a front left lower control arm with ball joint made to match OE form, fit and function. It fits many vehicles, among them the 2008-2009 Chevrolet Equinox, 2012-2015 Chevrolet Captiva Sport and 2008-2009 Pontiac Torrent. See the Buyer's Guide tab for the full list and engine details.
The lower control arm links the vehicle's chassis to the steering knuckle through its ball joint. This lets the suspension travel up and down while holding the wheel in position. Beck/Arnley designs its parts as direct replacements for original equipment, with close attention to form, fit and function.
Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and play in the ball joint. Other suspension and steering parts can cause similar symptoms, so diagnose the cause before replacing. This arm is sold individually for the left side. Replacing both sides together is recommended.
Interchange: 62262004 · RK620661 · CMS50163 · 4520278J00 · 4520278J01 · 4520278J02
This part cross-references / interchanges with the following part numbers:
Will this Chevy Equinox control arm fit my 2008-2009 Equinox?
Yes, it is listed for the 2008-2009 Chevrolet Equinox in the front left lower position, and it also fits the 2012-2015 Chevrolet Captiva Sport. Check the Buyer's Guide tab to confirm your vehicle.
Is this a control arm and ball joint assembly?
Yes. The control arm comes with its ball joint, so the arm and joint are replaced together in a single installation.
Which position does this control arm fit?
It is the front left lower control arm. It is sold individually, and replacing both sides together is recommended.
What are signs the lower control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear and play in the ball joint. Other suspension parts can cause similar symptoms, so inspect before replacing.
Is a wheel alignment needed after installation?
An alignment check is recommended after replacing a control arm. Follow the vehicle service information for installation steps, torque values and which fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.