Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7682
$335.99
(You save)
Steer with confidence using this Beck/Arnley control arm (P/N 102-7682), the front left lower unit that locates the wheel and carries the ball joint that lets the steering knuckle pivot. It's a direct-fit replacement for the 2009-2012 Infiniti FX35, 2013 Infiniti FX37, 2009-2013 Infiniti FX50, and 2014-2017 Infiniti QX70 — see the Buyer's Guide tab for engine-level fitment.
OE-matched: designed to match Original Equipment form, fit, and function for the listed foreign-nameplate applications.
Complete assembly: the control arm comes with the ball joint pre-installed for a complete installation.
Durable build: steel, iron, or aluminum construction (varies by application) for durability and rust/corrosion resistance.
Where applicable: new hardware and bushings are included where applicable — consult the vehicle service information for the correct fasteners and whether they may be reused.
A worn control arm or ball joint can show up as clunking over bumps, wandering or loose steering, and uneven tire wear. If a failed arm or ball joint is the cause, this application-specific assembly replaces it.
What position on the vehicle is this control arm and ball joint assembly?
It is the front left (driver's side) lower control arm, supplied with the ball joint pre-installed.
Which vehicles does the Beck/Arnley control arm fit?
It fits the 2009-2012 Infiniti FX35, 2013 Infiniti FX37, 2009-2013 Infiniti FX50, and 2014-2017 Infiniti QX70. Check the Buyer's Guide tab to confirm your vehicle.
Is the ball joint included?
Yes. The control arm comes with the ball joint for a complete installation, so you replace both in one assembly.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
What are the signs this part may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to a worn control arm or ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7682
Keep the front wheel located and steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-8228), a direct-fit Subaru Crosstrek control arm for the front left lower...
Shopping Nissan Frontier upper control arms? The Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6321 is a front left upper unit that bolts your wheel's location back to spec. This...
Steady your front-end handling with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-8055, also written 1028055), a Subaru Forester control arm that drops in as a direct...
Sharpen steering response and keep your front suspension located with the Beck/Arnley control arm assembly (P/N 102-8402), a direct-fit replacement for the 2017-2024 Tesla 3 and 2020-2024 Tesla Y...
Get your front suspension tracking straight again with the Beck/Arnley control arm (P/N 102-7655), a front right lower control arm with an integrated ball joint that mounts the wheel to the chassis,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
