Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7775
$202.99
(You save)
Keep the front wheel located and the steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N: 102-7775), a front left lower unit that locates the wheel, controls suspension travel, and connects the steering knuckle through its integrated ball joint. It drops in as a direct-fit replacement for the 2008-2010 Subaru Impreza — see the Buyer's Guide tab for engine-specific coverage.
Complete assembly: the control arm ships with its ball joint already fitted for a complete, one-piece installation.
OE form, fit and function: engineered to match the original component so it installs like the factory part on the listed applications.
Durable construction: built from steel, iron, or aluminum for strength and rust/corrosion resistance.
Ready to install: new bushings and mounting hardware are included where applicable, and it is application-specific for this vehicle.
Worn control-arm bushings or a failing ball joint can cause clunking over bumps, wandering or imprecise steering, and uneven tire wear. If a worn arm or ball joint is the cause, replacing this assembly addresses those signs. Diagnose the condition before ordering.
It is a front left lower direct-fit replacement for the 2008-2010 Subaru Impreza. Check the Buyer's Guide tab to confirm engine-specific coverage for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with its ball joint already fitted, so you install one complete assembly rather than separate pieces.
Are bushings and hardware included?
New bushings and mounting hardware are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are the signs I may need to replace it?
Clunking over bumps, wandering or imprecise steering, and uneven tire wear can indicate worn control-arm bushings or a failing ball joint. Diagnose the cause before replacing.
What is it made of?
It uses steel, iron, or aluminum construction for durability and rust/corrosion resistance, and is application-specific for this vehicle.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7775
Locate the front wheel and keep steering response tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8296, which positions the wheel and lets the suspension travel while...
Tighten up a loose, clunking front end with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6818, the front left lower unit that locates the wheel and lets it pivot and travel...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
