Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8052
$175.99
(You save)
Keep the front suspension of your Subaru tracking straight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8052. This front right lower unit is a direct-fit replacement for the 2009-2013 Subaru Forester and 2011-2014 Subaru Impreza — see the Buyer's Guide tab for engine-level fitment. It locates the front wheel and lets it pivot through the integrated ball joint, while the bushings help isolate road vibration.
Complete assembly: the control arm comes with the ball joint for a complete installation.
Construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable.
Application specific: built to match OE form, fit and function for this vehicle.
Beck/Arnley designs its parts as direct OE-replacement components for foreign-nameplate applications, with attention to form, fit, and function. Worn control-arm bushings or a loose ball joint can show up as clunking over the front end, steering wander, or uneven tire wear; if a failed original arm or joint is the cause, this assembly replaces it. Replacing left and right sides together is good practice for balanced handling.
It's a direct-fit replacement for the 2009-2013 Subaru Forester and 2011-2014 Subaru Impreza. See the Buyer's Guide tab to confirm the engine-level fitment for your vehicle.
What position is this control arm for?
It is the front right lower control arm and ball joint assembly for the listed applications.
Does it include the ball joint?
Yes. The control arm comes with the ball joint pre-installed for a complete installation, so you replace both in one step.
Are new hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Should I replace both sides at once?
It's sold individually as the front right lower unit. Replacing the left and right sides together is good practice for balanced, even handling.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8052
Locate the front wheel and keep steering response tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8296, which positions the wheel and lets the suspension travel while...
Tighten up a loose, clunking front end with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6818, the front left lower unit that locates the wheel and lets it pivot and travel...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
