Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8147
$144.99
(You save)
Steady the front suspension and locate the wheel with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-8147). It drops in as a direct replacement for the front left upper position on the 2004-2008 Acura TL — see the Buyer's Guide tab for engine-level details. The control arm ships with the ball joint pre-installed for a complete corner-by-corner installation.
Complete assembly: control arm comes with the ball joint, so the pivot and mounting points are addressed in one part.
Durable construction: built from steel, iron, or aluminum for strength and rust/corrosion resistance.
OE match: designed to match OE form, fit, and function for the listed foreign-nameplate application.
Hardware & bushings: new hardware and bushings included where applicable.
The control arm positions the wheel and, through its ball joint, allows the steering knuckle to pivot and travel while keeping suspension geometry in spec. If a worn arm or ball joint is behind clunking or knocking over bumps, imprecise steering, or uneven tire wear, this assembly replaces it. Application specific for this vehicle.
It is a direct replacement for the front left upper position on the 2004-2008 Acura TL. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
Does the ball joint come with the control arm?
Yes. The ball joint comes pre-installed on the control arm, so the assembly is ready for a complete installation at that corner.
What is this control arm made of?
It is built from steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
What are signs this control arm or ball joint may need replacing?
Clunking or knocking over bumps, imprecise or loose steering, and uneven tire wear can point to a worn arm or ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8147
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
