Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8221
$228.99
(You save)
Keep the front suspension located and the steering responsive with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8221. This front right (passenger-side) lower unit drops in as a direct replacement for the 2014-2020 Acura RLX, arriving with the ball joint already installed for a complete replacement. It is built to match original-equipment form, fit, and function.
Complete assembly: the control arm comes with the ball joint fitted, so you address both wear points in one installation.
Construction: steel, iron, or aluminum depending on the application, for durability with rust and corrosion resistance.
Position-specific: cataloged for the front right (passenger-side) lower position.
OE-matched: engineered to match OE form, fit, and function on the listed application.
Worn control-arm bushings or a failing ball joint can cause clunking over bumps, loose or wandering steering, and uneven front tire wear. If the original component is the cause, this assembly replaces it. Consult the vehicle service information for the correct fasteners and torque, and whether any may be reused. See the Buyer's Guide tab for engine-level fitment details.
Interchange: 51370TY2A01 · 2703528171 · 62240135
This part cross-references / interchanges with the following part numbers:
51370TY2A01, 2703528171, 62240135
Frequently Asked Questions
What position does this control arm assembly fit?
It is cataloged for the front right (passenger-side) lower position on the listed application.
Does it include the ball joint?
Yes. The control arm ships with the ball joint already installed, so you replace both in a single installation.
What vehicles does 102-8221 fit?
It is a direct replacement for the 2014-2020 Acura RLX. See the Buyer's Guide tab for engine-level fitment details.
What is this assembly made of?
Steel, iron, or aluminum depending on the application, providing durability with rust and corrosion resistance.
What are signs I may need to replace it?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can point to worn bushings or a failing ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8221
Locate the front wheel and keep steering response tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8296, which positions the wheel and lets the suspension travel while...
Tighten up a loose, clunking front end with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6818, the front left lower unit that locates the wheel and lets it pivot and travel...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
