Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8241
$225.99
(You save)
Restore precise wheel location and quiet suspension movement with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8241, cataloged for the rear right upper position. It installs as a direct-fit replacement on the 2014-2020 Acura RLX (see the Buyer's Guide tab for engine-level details), pairing the control arm with a pre-attached ball joint so the assembly locates the wheel and lets the suspension articulate without excess play.
Beck/Arnley builds this assembly to match OE form, fit, and function for foreign-nameplate applications, sourced through its global network to meet the brand's requirements and specifications.
Complete assembly: the control arm comes with its ball joint for a one-piece installation.
OE-matched: engineered to match original-equipment form, fit, and function.
Construction: steel, iron, or aluminum for durability and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable.
Worn ball joints or bushings can show up as clunking over bumps, loose or wandering steering, and uneven tire wear. If a failed control arm or ball joint is the cause, this assembly replaces it. Replacing the matching side together helps keep suspension response balanced.
Interchange: 52510TY2A02
This part cross-references / interchanges with the following part numbers:
52510TY2A02
Frequently Asked Questions
What vehicle does this control arm assembly fit?
It is cataloged as a direct-fit replacement for the 2014-2020 Acura RLX. Check the Buyer's Guide tab and confirm the fitment for your vehicle.
Which position is this assembly for?
The catalog lists it for the rear right upper position. Verify the position matches the corner you are servicing before ordering.
Does the ball joint come with the control arm?
Yes. The control arm comes with its ball joint pre-attached, so it installs as one complete assembly.
Is mounting hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are the signs this part may need replacing?
Clunking over bumps, loose or wandering steering, and uneven tire wear can indicate a worn ball joint or bushings. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8241
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the front suspension properly located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8103, a front right lower unit that installs as an application-specific replacement...
Restore steering precision and quiet the clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-5535, also written 1025535). This front left upper control arm arrives...
Keep your front suspension properly located and your steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8380. This front right lower assembly drops in as a direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
