Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7582
$121.99
(You save)
Restore precise steering and wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7582, a front left lower unit that pairs the control arm with its ball joint for a complete corner. It installs as a direct-fit replacement for the 2011-2016 Hyundai Elantra, 2013-2014 Hyundai Elantra Coupe, 2013-2017 Hyundai Elantra GT, and 2012-2017 Hyundai Veloster — see the Buyer's Guide tab for engine-level fitment.
Complete corner: the control arm comes with the ball joint pre-assembled for a complete installation.
OE match: designed as a direct replacement built to match OE form, fit, and function for foreign-nameplate applications.
Durable build: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable; this is an application-specific part for the listed vehicles.
The control arm locates the lower suspension and the integrated ball joint allows the knuckle to pivot and travel. Worn signs may include clunking on acceleration, deceleration, or over bumps, loose or wandering steering, uneven tire wear, and torn bushings or a loose ball joint. Replace both sides together for balanced handling if the opposite side shows similar wear.
It fits the 2011-2016 Hyundai Elantra, 2013-2014 Hyundai Elantra Coupe, 2013-2017 Hyundai Elantra GT, and 2012-2017 Hyundai Veloster. Check the Buyer's Guide tab to confirm your vehicle.
What position is this assembly?
It is the front left (driver's side) lower control arm and ball joint assembly for the listed applications.
Does it include the ball joint?
Yes. The control arm comes with the ball joint pre-assembled for a complete installation.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs this part may need replacing?
Clunking on acceleration, deceleration, or over bumps, loose or wandering steering, uneven tire wear, and torn bushings or a loose ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7582
Restore steering precision and quiet the clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-5535, also written 1025535). This front left upper control arm arrives...
Keep your front suspension properly located and your steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8380. This front right lower assembly drops in as a direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
