Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8278
$209.99
(You save)
Replace a worn front right lower Nissan Altima control arm with the Beck/Arnley Control Arm with Ball Joint Assembly 102-8278. It drops in as a direct-fit replacement for the 2019-2025 Nissan Altima (see the Buyer's Guide tab for engine-level fitment), pairing the control arm and its ball joint in one unit so you replace the front right lower lower control arm Nissan Altima corner in a single step.
Complete assembly: the control arm comes with the ball joint installed for a complete, ready-to-fit repair.
OE match: engineered to match OE form, fit and function for foreign-nameplate applications.
Durable construction: built from steel, iron, or aluminum for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable; consult the vehicle service information for the correct fasteners.
The control arm locates the front wheel and lets the suspension travel while the integrated ball joint allows steering and suspension movement. Signs it may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. This is an application-specific part for the listed vehicle.
Interchange: 2703709252 · 545006CA0A · RK623780
This part cross-references / interchanges with the following part numbers:
2703709252, 545006CA0A, RK623780
Frequently Asked Questions
Does this Beck/Arnley control arm and ball joint assembly fit my Nissan Altima?
It is a direct-fit replacement for the 2019-2025 Nissan Altima. Check the Buyer's Guide tab to confirm the engine-level fitment for your vehicle.
Which corner is this control arm for?
It is the front right (passenger-side) lower control arm assembly for the listed application.
Does the ball joint come with this control arm?
Yes. The ball joint is included with the control arm as a complete assembly for a single-step installation.
What is this Beck/Arnley control arm made of?
It is built from steel, iron, or aluminum depending on the application, for durability and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8278
Replace a worn Nissan Versa control arm and bring back steady, quiet handling with the Beck/Arnley Control Arm with Ball Joint (P/N 102-8296, also written 1028296). This front right lower control arm...
Keep the front wheel properly located and the steering knuckle pivoting freely with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-6818). This Nissan Sentra control arm drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
