Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8292
$179.99
(You save)
Restore precise front-suspension geometry with the Beck/Arnley control arm, part number 102-8292 — a front right lower control arm and ball joint assembly that locates the wheel to the chassis, allows the suspension to travel, and lets the integrated ball joint pivot for steering. It drops in as a direct replacement for the 2017-2022 Hyundai Ioniq, 2019-2023 Hyundai Kona Electric, 2017-2022 Kia Niro, and 2019-2022 Kia Niro EV; see the Buyer's Guide tab for the full engine-level list.
Complete assembly: the control arm ships with its ball joint pre-installed for a straightforward installation.
OE form, fit and function: designed as a direct-fit replacement for the original equipment on foreign nameplates.
Durable build: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Application-specific: new hardware and bushings are included where applicable for this vehicle.
Worn suspension parts can show up as clunking or knocking over bumps, wandering steering, or uneven front tire wear. If the original control arm or ball joint is the cause, this assembly replaces it. This is the front right lower unit — replacing the opposite side at the same time is a good practice for balanced handling.
Interchange: 2703668229 · 54501G2100 · RK623888
This part cross-references / interchanges with the following part numbers:
2703668229, 54501G2100, RK623888
Frequently Asked Questions
What is the Beck/Arnley 102-8292?
It is a front right lower control arm with an integrated ball joint. The arm locates the wheel to the chassis and allows suspension travel, while the ball joint pivots for steering.
Which vehicles does this control arm fit?
It fits the 2017-2022 Hyundai Ioniq, 2019-2023 Hyundai Kona Electric, 2017-2022 Kia Niro, and 2019-2022 Kia Niro EV. Check the Buyer's Guide tab to confirm your exact vehicle.
Does the ball joint come already installed?
Yes. The control arm ships with its ball joint for a complete installation, so you don't have to source or press in a separate ball joint.
Which position is this control arm?
This is the front right lower control arm assembly for the listed applications.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking or knocking over bumps, wandering or loose steering, and uneven front tire wear. Have the cause diagnosed, since these symptoms can have other sources.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8292
Tighten up a loose, clunky front end with the Beck/Arnley control arm and ball joint assembly, MPN 102-8406 — a direct-fit replacement for the 2017-2024 Tesla 3. It installs in the front lower...
Keep the rear suspension of your LS430 control arm setup properly located with the Beck/Arnley Control Arm and Ball Joint Assembly, MPN 102-8161. It drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
