Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8294
$257.99
(You save)
Keep your steering tight and your front suspension planted with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8294 — a direct-fit Nissan Murano control arm for the front right lower position. This is a complete control arm and ball joint assembly, so the arm arrives with its ball joint pre-installed for a straightforward replacement on the 2015-2024 Nissan Murano.
The control arm locates the wheel, absorbs road inputs through its bushings, and pivots on the ball joint to allow steering and suspension travel. Worn bushings or a loose ball joint on the original can cause clunking over bumps, uneven tire wear, and vague steering — signs this Murano lower control arm may need replacing.
Complete assembly: the control arm comes with the ball joint for a full installation.
OE-matched: built to match Original Equipment form, fit, and function for foreign-nameplate applications.
Durable construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: includes new hardware and bushings where applicable.
An application-specific Beck/Arnley control arm for this vehicle.
What vehicle does the Beck/Arnley 102-8294 control arm fit?
It is a direct-fit replacement for the 2015-2024 Nissan Murano, in the front right lower position. See the Buyer's Guide tab to confirm the fit for your exact vehicle.
Does this control arm come with the ball joint?
Yes. The control arm comes with the ball joint pre-installed for a complete installation, so you replace the arm and ball joint as one assembly.
Which position on the Murano is this for?
It is the front right lower control arm. It installs on the front passenger-side lower suspension of the listed Nissan Murano applications.
What are the signs my control arm needs replacing?
Clunking over bumps, uneven or accelerated tire wear, and loose or vague steering can point to worn bushings or a loose ball joint. Have the cause diagnosed before replacing.
Is new hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8294
CONTROL ARM WITH BALL JOINTBeck/Arnley parts are designed to be a direct replacement for Original Equipment (OE) applications across all foreign nameplates, with special attention given to form, fit,...
CONTROL ARM WITH BALL JOINTBeck/Arnley parts are designed to be a direct replacement for Original Equipment (OE) applications across all foreign nameplates, with special attention given to form, fit,...
Restore precise steering geometry and quiet the front suspension with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8166. This front left upper rearward assembly drops in as a...
Restore precise steering and quiet the front suspension with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-7724). This front left lower rearward unit combines the control...
Restore tight, predictable handling with the Beck/Arnley control arm and ball joint assembly (P/N 102-7778), a direct-fit replacement for the front right lower position on the 2006-2009 Subaru Legacy...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
