Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8342
$85.99
(You save)
Keep your rear suspension located and tracking true with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8342. This rear upper forward control arm arrives with its ball joint already assembled for a complete installation, and it drops in as a direct replacement for the 2015-2021 Kia Sedona — see the Buyer's Guide tab for engine-level details.
Complete assembly: the control arm comes with the ball joint for a one-piece installation.
OE form, fit and function: designed as a direct replacement for Original Equipment applications across foreign nameplates, with attention to form, fit, and function.
Durable construction: built from steel, iron, or aluminum depending on the application for strength and rust/corrosion resistance.
Hardware and bushings: new hardware and bushings included where applicable.
The control arm helps locate the wheel and connect it to the chassis, while the integrated ball joint lets the suspension pivot and articulate over the road. Worn signs may include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear — if a failed control arm or ball joint is the cause, this assembly replaces it. Replacing the arm and ball joint together restores a fresh pivot point in one step.
This part cross-references / interchanges with the following part numbers:
526253, 55250A9000, CB63665, CMS901229
Frequently Asked Questions
What vehicle does the 102-8342 fit?
It is a direct replacement for the 2015-2021 Kia Sedona. Check the Buyer's Guide tab to confirm the correct application for your specific vehicle.
Does this include the ball joint?
Yes. The control arm comes with the ball joint already assembled, so you install both together as one complete unit.
Where does this control arm mount?
It is the rear upper forward control arm assembly for the listed application, helping locate the wheel and connect the suspension to the chassis.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs I may need to replace it?
Clunking or knocking over bumps, loose or wandering steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8342
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
