Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8357
$133.99
(You save)
Steady steering and tighten up front-end play with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8357 (also listed as 1028357). This Beck/Arnley control arm installs at the front right upper position and pairs the arm with its ball joint for a complete corner in one part. It's an application-specific fit for the 2017-2024 Tesla 3 and the 2020-2022 Tesla Y — see the Buyer's Guide tab to confirm your exact configuration.
Matches OE form, fit and function: designed as a direct replacement for the original-equipment assembly on the listed applications.
Complete corner: the control arm comes with its ball joint for a complete installation.
Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
New hardware and bushings included where applicable — confirm your vehicle's service procedure for the correct fasteners.
As a locating link for the suspension, the control arm helps support and position the wheel while the ball joint allows steering and suspension travel. Signs it may need replacing include clunking on acceleration or over the road, loose or wandering steering, and uneven tire wear. This assembly is also known as a control arm and ball joint assembly.
Does this Beck/Arnley control arm come with the ball joint?
Yes. The control arm comes with its ball joint for a complete installation, so you replace the full assembly as one unit.
Where does this assembly install?
It fits the front right upper position on the listed applications. Replacing the matched left and right corners together helps keep steering and tire wear even.
Will this fit my Tesla Y?
This Tesla Y control arm is an application-specific fit for the 2020-2022 Tesla Y. Check the Buyer's Guide tab to confirm your exact vehicle.
Does it fit a Tesla 3?
Yes. This Tesla 3 control arm is listed for the 2017-2024 Tesla 3. Verify your configuration on the Buyer's Guide tab before ordering.
What are signs my control arm needs replacing?
Common signs include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8357
Replace a worn Nissan Versa control arm and bring back steady, quiet handling with the Beck/Arnley Control Arm with Ball Joint (P/N 102-8296, also written 1028296). This front right lower control arm...
Keep the front wheel properly located and the steering knuckle pivoting freely with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-6818). This Nissan Sentra control arm drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
