Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8439
$195.99
(You save)
Keep your front end located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-8439), a Hyundai Elantra control arm that connects the steering knuckle to the chassis and pivots on its built-in ball joint through suspension and steering travel. It installs in the front left lower position as a direct-fit replacement for the 2021-2025 Hyundai Elantra, and the control arm comes with the ball joint for a complete installation.
Complete assembly: this Beck/Arnley control arm ships with its ball joint, so a worn arm and joint are replaced together as one part.
Durable construction: steel, iron, or aluminum build for durability and rust/corrosion resistance.
OE form, fit and function: engineered as a direct replacement for the Original Equipment application, with attention to form, fit and function.
Application specific: new hardware and bushings included where applicable, matched to this vehicle.
Signs this part may need replacing include clunking or knocking from the front suspension, uneven front tire wear, and loose or wandering steering. If a worn lower control arm or ball joint is the cause, this assembly replaces it.
Interchange: 54500AA100
This part cross-references / interchanges with the following part numbers:
54500AA100
Frequently Asked Questions
What vehicles does the Beck/Arnley 102-8439 fit?
It is a direct-fit replacement for the 2021-2025 Hyundai Elantra, installing in the front left lower position. See the Buyer's Guide tab to confirm your exact vehicle.
Does this control arm and ball joint assembly include the ball joint?
Yes. The control arm comes with its ball joint for a complete installation, so you replace the arm and joint together as one assembly.
What is the 102-8439 made of?
Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Are bushings and hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are common signs a lower control arm on my Hyundai Elantra needs replacing?
Common signs include clunking or knocking from the front suspension, uneven front tire wear, and loose or wandering steering. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8439
Tighten up a loose, clunky front end with the Beck/Arnley control arm and ball joint assembly, MPN 102-8406 — a direct-fit replacement for the 2017-2024 Tesla 3. It installs in the front lower...
Keep the rear suspension of your LS430 control arm setup properly located with the Beck/Arnley Control Arm and Ball Joint Assembly, MPN 102-8161. It drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
