Quiet the clunks and restore precise wheel location with the Beck/Arnley Suspension Control Arm Bushing 101-7804. This front lower control arm bushing cushions the joint between the control arm and the chassis, isolating road vibration and helping keep suspension geometry in check. It installs as a direct-fit replacement for the 2009-2014 Acura TSX and 2008-2012 Honda Accord — see the Buyer's Guide tab for the full engine-level application list.
Worn control arm bushings can show up as clunking on acceleration, deceleration, or over bumps, imprecise steering, and uneven tire wear. If a failed bushing is the cause, this replaces it. Replacing bushings in pairs across the axle is a good practice for balanced handling.
Interchange: 45G9217 · 51391TA0A01 · ACR203 · K201639 · FB843 · 5651217
This part cross-references / interchanges with the following part numbers:
What vehicles does this bushing fit?
It's a direct-fit replacement for the 2009-2014 Acura TSX and 2008-2012 Honda Accord. Check the Buyer's Guide tab to confirm the exact engine-level fit for your vehicle.
Where is this bushing located?
It's the front lower suspension control arm bushing, cushioning the joint between the control arm and the chassis.
What is this bushing made of?
It's molded from a high grade rubber compound and is resistant to heat, wear, salt, road grime, and oils for durability in daily driving.
What are signs my control arm bushing needs replacing?
Common signs include clunking on acceleration, deceleration, or over bumps, imprecise steering, and uneven tire wear. Diagnose the cause before replacing.
Should I replace both sides at once?
Replacing the bushings on both sides of the axle together is a good practice for balanced, even handling, though it isn't strictly required.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
