Cushion suspension movement and quiet the ride with the Beck/Arnley Suspension Control Arm Bushing (P/N 101-7858), a direct-fit replacement for the front lower rearward position. It installs on the 2006-2007 Subaru B9 Tribeca, 2005-2009 Subaru Legacy, 2005-2009 Subaru Outback, and 2008-2014 Subaru Tribeca — see the Buyer's Guide tab for engine-level fitment.
This bushing isolates the control arm at its mount, absorbing road shock and helping to locate the arm so the suspension geometry stays as intended. Worn or cracked bushings can allow extra movement, producing clunks on acceleration, deceleration, or over rough pavement, plus uneven tire wear and loose handling. If a failed bushing is the cause, this replaces it.
Interchange: W53353 · K201605 · FA1297 · MS80427 · 20204AG01A · 20204AG01B · 20204XA00B · 20204XA00B9E · W0133181922
This part cross-references / interchanges with the following part numbers:
What does this control arm bushing do?
It cushions the control arm at its mount, absorbing road shock and helping locate the arm so the suspension geometry stays as intended.
What position is this bushing for?
It is cataloged for the front lower rearward position on the listed Subaru applications.
Which vehicles does it fit?
The 2006-2007 Subaru B9 Tribeca, 2005-2009 Subaru Legacy, 2005-2009 Subaru Outback, and 2008-2014 Subaru Tribeca. Check the Buyer's Guide tab for engine-level fitment.
What are signs the bushing may need replacing?
Clunks on acceleration, deceleration, or over rough roads, along with uneven tire wear or loose handling. Diagnose the cause before replacing.
What is it made of?
A high-grade rubber compound that is resistant to heat, wear, salt, road grime, and oils for durability.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
