Cushion suspension movement and keep your front suspension geometry in check with the Beck/Arnley control arm bushing (P/N 101-8781, also written 1018781). It fits the front left lower control arm on the 2005-2010 Acura RL, dropping in as a direct replacement designed to match the OE form, fit, and function of the original bushing on this application.
The control arm bushing locates the control arm to the chassis while absorbing road vibration and allowing the arm to pivot through suspension travel. Worn or cracked bushings can cause looseness, clunking on acceleration or over uneven roads, and uneven tire wear; if a failed front left lower bushing is the cause, this replaces it. Inspect the mating hardware and follow the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 51362SJA010
This part cross-references / interchanges with the following part numbers:
What vehicle does the Beck/Arnley control arm bushing 101-8781 fit?
It is a direct-fit replacement for the 2005-2010 Acura RL. See the Buyer's Guide tab to confirm the fit for your exact vehicle.
Which position is this bushing for?
The catalog lists it for the front left lower control arm on the 2005-2010 Acura RL.
What is this control arm bushing made of?
It is made from a high-grade rubber compound and is resistant to heat, wear, salt, road grime, and oils.
What are the signs a control arm bushing may need replacing?
Looseness, clunking on acceleration or over uneven roads, and uneven tire wear can be signs. Diagnose the cause before replacing, since these symptoms have other possible sources.
What interchange number does this part cross to?
It replaces interchange number 51362SJA010. Verify against your original part before ordering.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
